Monthly Archives: November 2010

Spyderco Endura Firefighter knife

Backbone cut My next project is also on a Spyderco Endura. This one is a gift for a Firefighter, so it has the FF Shield and his Badge number. The design was selected from my portfolio and I had the … Continue reading

Posted in Knives | Leave a comment

Spyderco Endura – Bronco Completed

Here are two views of the completed Spyderco Endura. Total engraving time was six hours. I did a much more elaborate font for the lettering than I normally use. Since it is a Christmas present it needed just a little fancier … Continue reading

Posted in Knives | Leave a comment

Bronco knife update

The shading is just about complete. Another two hours of engraving and the shading is just about complete. Not sure if you can see the details of the bronco’s mane. I cut individual hairs instead of just stippling for a … Continue reading

Posted in Knives | Leave a comment

Spyderco Endura Bronco knife

I’ve been working on the design for this knife for a few days. Drawn and re-drawn it numerious times. I just could not get a horse that I liked. Since the horse is a featured part of the design I … Continue reading

Posted in Knives | Leave a comment

Remington 700 in 25-06, Engraved Grip Cap

  Yesterday I started work on a Remington Model 700 rifle. Since the barrel and receiver are parkerized we are just going to put three initials on the bolt arm and to really personalize this Christmas gift I will add … Continue reading

Posted in Firearms | Leave a comment