Tag Archives: hand engraved

Spyderco Delica – Hand engraved

The backside is completely covered with engraving. Continue reading

Posted in Knives | Tagged , , , , , | Leave a comment

FRANCHI shotgun engraving complete.

The combination of soft alloy and sharp carbide graver made this fun to engrave. Nervous but fun too. Continue reading

Posted in Firearms | Tagged , , | Leave a comment

FRANCHI shotgun engraving

I have a beautiful Franchi Instinct SL shotgun to engrave today.

This is a wonderful shotgun, very sleek, light and well made. I’d love to own it. This will be a graduation gift from Dad & Mom to son and graduation is this Friday Continue reading

Posted in Firearms | Tagged , , , , | Leave a comment

Sweet 16 – Update #2

Today I have mounted the silver pendant in GRS Thermolock (using some painters tape to protect the finish) and have laid out the final design. Continue reading

Posted in Jewelry | Tagged , , , , , | Leave a comment

Sweet 16 – UPDATE

For this project I am hand engraving a silver pendant and the silver is only 26 gauge thick. Continue reading

Posted in Jewelry | Tagged , , , , , | Leave a comment

Henry Yellowboy ~ Custom engraving

Starting with a simple border around this side of the receiver and then the Grandfather’s initials followed by the Grandson’s initials. Finally the ranch brand in the center, Continue reading

Posted in Firearms | Tagged , , , , , , , , , , | Leave a comment

Spyderco Delica hand engraved – Update.

The Steampunk themed knife is looking pretty wild. The pocket clip goes on and runs left to right and I designed this to show gears and things underneath the clip. Continue reading

Posted in Knives | Tagged , , , , , , , | Leave a comment

Baptism Bracelets

The lettering and numbers were so small I could not do it without the microscope. A #50 round graver was used to make the hand pushed cuts. Continue reading

Posted in Jewelry | Tagged , , , , | Leave a comment

Alexanders 1911 Slide

Today I shot a short video so you can see how I engrave firearms. A new camera to work with so this is a bit of an experiment just to learn the equipment. Continue reading

Posted in Firearms | Tagged , , | Leave a comment

Silver Sheriff badge Layout

This morning I practiced the edge border until I had it down perfectly. You can see the final edge border that will be used on the silver badge above the “TEN” in Lieutenant. There will be a very thin silver border and inside that will be a weaving cut design and finally a wriggle cut. Continue reading

Posted in Badges | Tagged , , , , , , | Leave a comment